TraSys® Pioneering Water-Based Technology for the Rotational Molding Industry

Benefits

Stoner Coating & Release Systems supply the plastic rotational molding industry with the best in water-based mold release coatings. Free of alcohol and solvents, these coatings meet all existing and anticipated environmental regulations. Stoner coatings yield consistent, controlled release for maximum performance.

Rotational molders use Stoner release coatings because:

TraSys® 420
More info.
TraSys® 414
More info.
TraSys® 500
More info.
TraSys® 715
More info.
Release Type Semi-Permanent, General-Purpose Semi-Permanent, High Release Semi-Permanent, General-Purpose Semi-Permanent, Light Release
Resin Carrier Water Water Water Water
Typical Uses Mold Internals Part Lines, Removable Pins, High Releases Mold Internals, Open Flame Large Flat Surfaces, Difficulty in Containing Warpage
Solvent Free Yes Yes Yes Yes
Alcohol Free Yes Yes Yes Yes
Recomm. Compat. Compounds LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols
Apply to Mold Warm2 Warm2 Warm2 Warm2
Min. Cure Temp. /
Min. Cure Time
132°C (270°F)3 /
5 minutes
132°C (270°F)3 /
5 minutes
132°C (270°F)3 /
5 minutes
132°C (270°F)3 /
5 minutes
Agitation Required Slight Slight Slight Slight
Product Cosmetics Satin Satin Satin Satin
Appl. Frequency Varies with Function Varies with Function Varies with Function Varies with Function
Action if Frozen Thaw, Agitate Thaw, Agitate Thaw, Agitate Thaw, Agitate
  1. Non-ozone depleting, noncarcinogenic solvent, No VOC content.
  2. Hot to the touch; approximately 48°-60°C (120°-140°F).
  3. Inner mold temperature; normally accomplished by cycling coated mold when empty.
  4. Air cures rapidly on substrates at 32°-38°C (70°-100°F). Introduction of 149°C (300°F) heat after application enhances cure and prolongs durability of coating.