The “small stuff” often matters most in rotational molding – especially for cause of defects, scrapped parts, and decreased production efficiency.
Inserts, tight radii, threads, and deep cavities are often hard-to-fill areas of rotationally molded parts. This common problem can result in weak or defective components of the molded part leaving it unusable.
The new, Stoner RotoFlow™ increases the flow of polyolefin and nylon resins into these difficult areas producing a fully molded part and nearly eliminating voids, pinholes, bridging, thinning, and static lines on the surface.
Users have reported higher part quality, increased production efficiency, and reduced operational waste allowing them to achieve higher production goals in less time using this product.
Product molded without RotoFlow
Product molded using RotoFlow
Stoner RotoFlow™ does not contain ozone depleting substances or chlorinated solvents. Stoner RotoFlow™ is sprayed directly onto the internal mold surface and is suitable for use with most metal surfaces.
To request a sample of Stoner RotoFlow™ click here or for more information contact us.