NEWS

Stoner RotoFlow™ Enhanced for Crosslinked Polyethylene

Nov 1, 2018, 14:09 PM by Peter Taraborelli
Stoner Molding Solutions, the world’s largest manufacturer of rotational mold releases, announces the re-development of RotoFlow™ a high-efficiency mold coating for rotomolded polyolefin and nylon resins.

Quarryville, PA (October 2016)

Stoner Molding Solutions, the world’s largest manufacturer of rotational mold releases, announces the re-development of RotoFlow™ a high-efficiency mold coating for rotomolded polyolefin and nylon resins.

Stoner RotoFlow™ was released in 2015 as a flow enhancer to increase detail in rotationally molded polyolefin and nylon parts. Now the NEW RotoFlow™ is available in a larger 13oz size with a new formula that is compatible with crosslinked polyethylene.

Inserts, tight radii, threads, and deep cavities are often hard-to-fill areas of rotationally molded parts. This common problem can result in weak or defective components of the molded part often leaving it unusable. Stoner RotoFlow™ increases the flow of polyolefin and nylon resins into these difficult areas producing a fully molded part and nearly eliminating voids, pinholes, bridging, thinning, and static lines on the surface.

Stoner RotoFlow™ users have reported higher part quality, increased production efficiency, and reduced operational waste allowing them to achieve higher production goals in less time using this product.

Stoner RotoFlow™ does not contain ozone depleting substances or chlorinated solvents.  Stoner RotoFlow™ is sprayed directly onto the internal mold surface and is suitable for use with most metal surfaces. Stoner RotoFlow™ is available at moldmoreparts.com.

Benefits of Stoner RotoFlow™

  • Improves the quality and consistency of rotomolded polyolefin and nylon parts.
  • Removes pinholes, voids, and blow outs.
  • Improves the appearance and operational performance of threads.
  • Increases the strength of inserts.
  • Contains no Class I or Class II ozone depleting substances.
  • Contains no CFC or HCFC propellants or solvents.
  • Contains no chlorinated solvents such as 1,1,1 trichloroethane or methylene chloride.

About Stoner Molding Solutions

Stoner Molding Solutions is the world’s largest manufacturer of rotational mold releases. Stoner has a solution for every molding application. If you can mold it, we can release it. All Stoner products are proudly manufactured in the USA and meet all Clean Air Act regulations. Stoner Molding Solutions is a division of Stoner Inc. a family-owned business located in Quarryville, PA since 1942.